This does reveal that I have not connected up the rear 5 pin DIN socket yet. I can only use it from the front in its current location though so this is not a priority.
Sunday, 17 November 2013
Point control
The wire in tube point control now complete. The double slip was already done. The other points are now completed with holes front and back to allow control from either side. The controls can be swapped from front to back by undoing a single screw on each one. I just need knobs for the protruding wires now.
This does reveal that I have not connected up the rear 5 pin DIN socket yet. I can only use it from the front in its current location though so this is not a priority.
This does reveal that I have not connected up the rear 5 pin DIN socket yet. I can only use it from the front in its current location though so this is not a priority.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment